A Reputation Built On Quality And Service

F.G.S. - Blog

Tempered Hole and Notch Locations

Minimum Glass Width: The minimum width of the product should be 8 times the thickness of the glass.

Edge Of Glass To Nearest Point of Hole: Glass less than 1/2" thick should not have holes located any closer than 1.5 times the thickness of the glass.  Glass thicker than 1/2" should not have holes located any closer than 2 times the thickness of the glass.

Corner Of Glass To Nearest Point of Hole: Holes should not be located any closer than 6.5 times the thickness of the glass.

Dimension Of Holes: The minimum dimension of a hole should be at least 1/16" larger than the thickness of the glass.  The maximum dimension of the hole should not be more than 1/3 the narrowest dimension of the piece.

Notches And Cutouts: All must have a fillet with radius equal to, or greater than the thickness of the glass.

 

 

Recent posts

  • Spontaneous Breakage

    Spontaneous breakage may occur with heat treated glass. Read more to learn about spontaneous breakage in heat treated glass products.
  • Tempered Hole and Notch Locations

    Holes and Notches, in tempered products, should be located within specified areas, in order to ensure the end products are…
  • Patterns and Pattern Materials

    By submitting a proper pattern, made from the proper material, customers will ensure a quality final product.
read more news